This is going to be a short post, because I don’t have a lot to say. I am sure you have been seeing the hubbub lately about how you can print ABS on top of a layer of PLA while keeping the bed temperature way down at 60C. I am mostly just here to tell you that it works, and it works extremely well!| Patshead.com Blog
First of all, I am NOT saying that you should buy a Sovol SV06. I wholeheartedly believe that the Bambu A1 Mini is by far the best $200 3D printer, …| blog.patshead.com
I promise. I am not trying to be a 3D-printing blog, but I got a new toy, so this is where my thoughts keep landing right now. First of all, I do not …| blog.patshead.com
No! I do not regret ordering my Bambu A1 Mini combo in November! I have been printing with it almost every day for the last two weeks, and it has …| blog.patshead.com
The title may almost be a lie! I feel that all of Bambu’s printers are a good value, and the Bambu P1P, P1S, and X1C are also fantastic printers for both beginners and veterans. If you have the budget, and you need the bigger printer, you should definitely invest in one of those. If your needs are smaller, and your budget is smaller, it is tough to go wrong with the Bambu A1 Mini.| Butter, What?!
NOTE: In my attempt to call attention to the problems, all photographs are lit and angled in a way that most highlight any printing imperfections. …| blog.patshead.com
I am not even sure about the direction this post is going to take. I had a pretty reasonable blog nearly completed over the weekend, which discussed …| blog.patshead.com