A little bit of DIY NAS and 3D-printing shenanigans - briancmoses.com
Increasing the capacity of my NAS by 3D-Designing and 3D-printing a drive caddy for 4x 2.5" SSDs. Is an all flash DIY NAS in my future?| blog.briancmoses.com
I’m not new to the world of Infiniband. I bought a pair of 20-Gigabit Mellanox Infiniband cards in 2016 to connect my desktop PC to my virtual …| blog.patshead.com
I was over at my friend Brian Moses’s house for pizza last night, and as soon as I walked in the door, he handed me one of the NanoKVM units …| blog.patshead.com
Increasing the capacity of my NAS by 3D-Designing and 3D-printing a drive caddy for 4x 2.5" SSDs. Is an all flash DIY NAS in my future?| blog.briancmoses.com
I have had Proxmox running on my Intel N100 mini PC for at least a week so far. It hadn’t been doing any real work until I migrated my first …| blog.patshead.com
I expected to write this blog AFTER all my virtual machines were migrated to the new hardware, but I am impatient, and I am recording enough …| blog.patshead.com
My evaluation of an interesting barebones NAS featuring: two 3.5-inch hard drive bays, a M.2 NVMe 2280 slot, an Intel N100 CPU, one DDR4 SODIMM, and two 2.5Gbps NICs.| blog.briancmoses.com
I have been doing a bad job. I have been neglecting the Butter, What?! blog. I haven’t posted anything here since I bought my Bambu A1 Mini in December. The good news is that everything I said about the Bambu A1 Mini in December is still true today, so I suppose I at least did a good job there, but I need to get back to posting here.| Butter, What?!
A small form factor, 4-bay DIY NAS featuring a Celeron N5105 CPU, 16GB of RAM, 128GB NVMe SSD, 2.5Gbps networking and TrueNAS SCALE for under $400.| blog.briancmoses.com
I have been selling the Topton N5105 NAS Motherboard on eBay for quite a few months now. The manufacturer of the motherboard has sent me a couple product catalogs full of all sort of interesting products based around this (or similar) small form factor motherboards.| Butter, What?!
