For the support test section, use the paint support function to set up the support as shown in the image and check the removability of the support and the cleanliness of the support surface.サポートテストの部分のみペイントサポート機能などで画像のようにサポートを立て、サポートの剥離性やサポート面の綺麗さを確認してください。| Thingiverse
this is a clearence test it will tell you how much room you have to print modles the clearence is added to one side and not the other so the total gap is the number stated all units are in mm| Thingiverse
Tells you in seconds, if your printers bed is bend or out of level in any way.Ultra fast, lowest material waste. 200mm ring run in less than 2 minutes.Simple as can be, no unnessessary bells and whistles.For any 3D printer of any make. Just know your printers bed size.Full bed level check or place smaller ones individually for a check of a certain bed area. Use a single ring, a choice of several rings or a ready rings combination.I provide a file for each single ring and rings combinations of...| Thingiverse
Printing setting:Infill : 0%Temperature : 200cBed Temperature : 70cwall : 2Bed adhesion : skirt| Thingiverse
Pretty simple cylinder. Good test to see how well your prints stick to the bed.Use the 40mm tall one to test various temperature settings and/or other settings until you find the one that sticks nice and firm to the bed after the print has finished. Once you have found the best setting, try the 100mm tall one. If it's still standing at the end of the print, your bed adhesion is good.Mine stuck just fine using an Ikea mirror...no tape, glue, hairspray, etc. I find that 70C for the first layer ...| Thingiverse
I had downloaded another fidget cube, and didn't like that I had to snap off the supports. I designed this from scratch, using the sample for reference. I designed with a flush hinge, so that no supports are needed. Nothing has to be removed from the part. Just work it loose right off the bed.| Thingiverse
A standard lattice cube. Try to test your printer using this model. Scale it up or down as you wish. You can find the original lattice cube solid part that was used to create a Solidworks assembly of 3 cubes. You can add a base part to the assembly as you wish. You can also find the Lib Feat Part of the 5 mm circle used to create the weldment structural member.Please note, I am not the one who innovated this idea of lattice cube. I was inspired by many of lattice cube designs I saw in youtube...| Thingiverse
Needed something simple for initial XYZ calibration, so I made this cube.| Thingiverse
This thing replaces the cap inside Twin Sticks for the Sega Saturn. A very common point of failure with no replacement parts available till now. Model by ShadowMask.This print was done in PLA and seems rock solid, will likely last even longer in ABS.| Thingiverse
